Running SoftICE on Windows for Workgroups 3.11

0 Likes

Problem:

I having problems runnin SI on WfW 3.11?

Resolution:

When running Soft-ICE on Windows for Workgroups 3.11, a CTRL-D

  will always bring you to the same place in assembly language.  The

  instruction is a POPAD and the module is the VKD.  To find the last

  place you were executing in 16 bit protected mode, use the VM command

  with 1 as a parameter ( VM 1 ).  This will give you the last CS:IP

  in 16 bit protected mode programs.

  Also, on some machines, it is required that you run Winice with

  a /K switch.  The symptoms of this problem are that when you get into

  the debugger, no keystrokes respond properly.

Old KB# 11539
Comment List
Anonymous
Related Discussions
Recommended