DriverStudio / DriverSuite Version 3.2 Requirements

0 Likes

Problem:

What are the DriverStudio / SoftICE 3.2 Requirements?

Resolution:

DriverStudio / SoftICE 3.2 Requirements

Note: Note: The DriverStudio Product installs kernel mode software that, like any other kernel mode software, has the potential to render your system unstable. While these occurrences are extremely rare, there is the possibility. For safety you should always back up irreplaceable data.

The following table applies to installable components of DriverStudio 3.2. Refer to the component-level Visual SoftICE Section below for requirements specific to Visual SoftICE, broken down by Target and Master.

<IMG title=32_DS style="MARGIN-TOP: 4px; MARGIN-BOTTOM: 4px; MARGIN-LEFT: 10px" src="ftp://ftp.compuware.com/pub/driverstudio/outgoing/KB/3.2_DS.jpg" border=0>

Key: T Target installation only

* SoftICE supports all Win9X platforms at the SoftICE 2.7 version functionality

Visual SoftICE supports the following Target configurations:<SPAN style="FONT-FAMILY: Arial">

<IMG title=32_VSI style="MARGIN-TOP: 4px; MARGIN-BOTTOM: 4px; MARGIN-LEFT: 10px" src="ftp://ftp.compuware.com/pub/driverstudio/outgoing/KB/3.2_VSI.jpg" border=0>

VisualSoftICE Master requires the following:

Standard PC - 64MB ram, 8MB free hard disk

Windows 2000 (XP if IP over 1394 is required)

Connectivity:

Standard serial port

Eithernet NIC 10/100

Firewire (1394)

Old KB# 11364
Comment List
Anonymous
Related Discussions
Recommended