I don't understand the "error" from Test Batch Runner

I have a test on my local harddrive.

The test runs fine.

I set up Test Batch Runner to call the test.

The TBR calls the test, the test runs, no problems.

I can use the Run Results Viewer to see the results and all is good.

 

But...

 

Back in the TBR on the output tab, after the test has completed, it prints this:

 

Element not found.
QTP is not launched.

 

That appears after the test is finished running. There were no errors reported by the test.

 

What's going on??