NOTICE: Our Community is moving. Get more information. Updated information on a New Login Process
Welcome to the Caliber Knowledge Base. The Knowledge Base contains a large amount of information that may answer any technical questions you have. To take full advantage of the Knowledge Bases across the Community please use the site search found in the top right hand corner of your Internet page. This search offers a wide range of customisation to narrow down your search to find your article. If you fail to find a solution here SupportLine will be able to assist you further.
Trying to export requirements using the document factory. It blows up with an error titled "Invalid Parameters" with a descriptions of "An item with the same key has already been added". I have not been able to find anything about this issue and re-installing Caliber didn't help. Any ideas?