Not sure if this is the right place for this question, but here it goes. I am seeing a lot of generic errors within the ZENworks Control Center for different bundles, but they don't have much information on them. I know there is a lot more information within the local logs that I cannot access, due to user is busy or access restrictions. Is there a way to have the ZENworks Agent write the logs to a different location rather than locally? Perhaps to a shared folder on a network drive? I'm not sure if there is a config file that tells it where to write the logs to but it would be very helpful if all the device logs were in a centralized location rather than only saved on the workstation.
I don't there's a file to automatically configure (welcome corrections if I'm wrong). You can specify the location by zac zeninfo <new_location>, for example zac zeninfo -C:\, you could likely make a bat file do that for you.