This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

eDirectory error 618 single object repair

dschaldenovell OpenText Employee

over 1 year ago

Good morning,

Just wanted to make sure I was doing this correctly, I have an object in eDirectory, in this case a post office, which is reporting an -618 error to repair this would I go the master replica of the partition and run "ndsrepair -J object number" in this case would that be the relative name 0001xxxx cn=Fxx_Axxx, so the command that I would use is, "ndsrepair -J 0001xxxx " is that correct? Along with which server this process is performed from or can it be any server within that partition/replica ring?

Thank you, and have yourself a nice start to the day

-Daniel

0 Mathias Braun over 1 year ago

The syntax is correct. As for for the server to run the command on: this strongly depends on the issue as such, a 618 might be caused by merely anything (from physical damage up to obit issues), so the object might not even exist in some replicas. Always keep in mind the the entry IDs for the same object will likely differ from replica to replica.
Cancel
Vote Up 0 Vote Down

Cancel

Menu

eDirectory User Discussions

eDirectory error 618 single object repair

Resources