Manual for the new Credential Vault interface in PAM 3.5 and 3.6

Good day everyone, can someone tell me if there is any manual for the new Credential Vault interface in pam 3.5 and 3.6, since there are some things that do change especially in the creation of WIndows credentials since there is this and the LDAP , in the manual of 3.5 it is similar to that of 3.2 and version 3.6 I no longer locate the credential creation part.

Regards

  • Good question! Within the PAM Console, there should be a question mark icon in the top-right to the left of the username dropdown and notification icon. Selecting this should contextually navigate you to the user guide in a new tab. So if on the Credential Vault page, it should open the "Vault Management" section of the documentation there for you. I hope that helps
  • Good question! Within the PAM Console, there should be a question mark icon in the top-right to the left of the username dropdown and notification icon. Selecting this should contextually navigate you to the user guide in a new tab. So if on the Credential Vault page, it should open the "Vault Management" section of the documentation there for you. I hope that helps
  • Good question! Within the PAM Console, there should be a question mark icon in the top-right to the left of the username dropdown and notification icon. Selecting this should contextually navigate you to the user guide in a new tab. So if on the Credential Vault page, it should open the "Vault Management" section of the documentation there for you. I hope that helps
  • Hi 

    I am very grateful for your response and support, however, and I forgot to comment on it, that step had already been done, but it only sent to a page with the following message: "The requested item was not found on this server".

    That is why I do not find any information and more detailed about the use of Credential Vault since it is a new interface, in the end it is practically the same but there are fields that already became mandatory and before they were not like that and could load credentials without that mandatory put the User DN among other things.

    So if anyone has documentation on the correct use of Credential Vault in PAM 3.5 and 3.6, I would greatly appreciate it.

    Regards.

  • Verified Answer

    The user guides are only available within the product contextually I believe. So I suspect that maybe not all the packages / modules were upgraded and perhaps that is why the requested resource could not be found. I'd recommend opening a service request for that issue if everything has been updated properly.

  • It is a very good option, I really appreciate your support.