Data Migration - Connector Appliance (Cx200) to ArcMC (C65xx)

0 Likes

This tech note explains how to migrate data from Connector Appliance models C3200 or C5200 to a new ArcSight Management Center C6500 appliance running ArcSight Management Center 2.0.

 

DO NOT USE this tech note for migrating Connector Appliance models Cx400 to ArcSight Management Center C6500. Instead refer to the ArcSight Management Center Migration Guide.

Labels:

ArcMC v2.0
Comment List
Anonymous
Parents
  • We followed the procedure and it has basically worked. Two caveats:

    - The Default ArcMC Rights Group was missing on the ArcMC box after the config restore. This made the web gui show a 500 error after logging in and only allowing System Admin Tasks. We have added the group manually and assigned it to admin users plus logged out and back in and the 500 error was gone.

    - ArcMC shows the local connectors as FATAL:Unreachable depite them working fine. We tried scanning the containers again but no change yet.

    Joachim

Comment
  • We followed the procedure and it has basically worked. Two caveats:

    - The Default ArcMC Rights Group was missing on the ArcMC box after the config restore. This made the web gui show a 500 error after logging in and only allowing System Admin Tasks. We have added the group manually and assigned it to admin users plus logged out and back in and the 500 error was gone.

    - ArcMC shows the local connectors as FATAL:Unreachable depite them working fine. We tried scanning the containers again but no change yet.

    Joachim

Children
No Data
Related Discussions
Recommended