Summary
Sometimes you may see a warning message when deploying Securedata configuration changes.

Products
Voltage SecureData

Environment
SecureData 6.x

Situation
When at System -> Deploy you may get below error.
------
Click the Deploy button to deploy all configuration changes.

Warning: the system has detected some configuration problems that may cause service issues if deployed.
Please correct these problems before deploying your configuration.
If you choose to deploy without correcting the problems, your services may not function as expected.

Configuration Problems
SOAP XML message validation based on WSDL specifications is Enabled. XML Validation has a major impact on performance and it is recommended only for testing.

Cause
SOAP XML Validation is enabled at System -> Advanced in the "Enable SOAP XML Validation" check box.

Voltage SecureData version 6.0 and later provides enhanced validation, allowing only SOAP calls that
strictly adhere to the published WSDL, including the correct upper/lower case of elements.

Artificial transaction health checks that use manually crafted SOAP calls might fail due to this change in
validation.
Invalid SOAP calls, which might have worked on previous versions, must be replaced by
valid calls.
To assist in locating invalid SOAP calls, check the Enable SOAP XML Validation check box.
Note that this validation can result in significantly slower performance

Resolution
There is no cause for alarm as this is only a warning/acknowledge message of the possible performance impact of selecting XML Validation.

You can go ahead and continue with Deploy in acceptance of the warning.

If not required you could uncheck the "Enable SOAP XML Validation" check box.

Knowledge Base Article Link

URL Name
KM000015760