This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Filr 4.3.x need run pre-upgrade.sh when upgrade to Filr 5.0 ?

Hi 

   I try to upgrade my filr 4.3.x to upgrade filr 5.0...I check page 122/188 the procedure...it show step -B seem need run the pre-uprade.sh...But it show on the Filr 3.4.x appliance.

whether thid document provide incorrect information...it shoule be on the filr 4.3.x appliance ==> I need run the pre-upgrade.sh on the Filr 4.3.x appliance.

Correct ?

Wencheng

Tags:

Parents
  • 0

    Hello Wencheng,

    I saw the same in the upgrade overview. But not in the text below. But as far as I can see there is no pre-upgrade script on the Filr 4 appliance, nor in the download section of the portal. So I think this image was a copy-paste from the upgrade from Filr3 -> 4 and is no longer necessary for the upgrade from Filr4 -> 5

  • 0 in reply to 

    HI

        My filr 4.3.1.2 is upgraded from filr3.x...now  I will upgrade it to filr 5.0

    I simple verify upgrade again.

    1. shutdown filr4.3.1.2 server.

    2. deploy filr 5.0 

    3. move the data disk of filr 4.3.1.2 server to filr5.x server as datadisk. I also add new disk as log disk.

    4. then boot filr 5.0 appliance

    5. I type need information on  configuration page...then it reboot ....it keep this status 

    which step I miss ?

    Wencheng

Reply
  • 0 in reply to 

    HI

        My filr 4.3.1.2 is upgraded from filr3.x...now  I will upgrade it to filr 5.0

    I simple verify upgrade again.

    1. shutdown filr4.3.1.2 server.

    2. deploy filr 5.0 

    3. move the data disk of filr 4.3.1.2 server to filr5.x server as datadisk. I also add new disk as log disk.

    4. then boot filr 5.0 appliance

    5. I type need information on  configuration page...then it reboot ....it keep this status 

    which step I miss ?

    Wencheng

Children