I can load it with modprobe or insmod.
With lsmod it is listed. size 138312, used by 0
If i run img en list Detected Hardware, there are still
“No network card detected”.
Does anyone know what to do?
New Broadcom Ethernet cards are constantly being released and not being detected by the ZENworks Imaging system.
The main problem appears to be that although the Broadcom module is normally backwards compatible, the hardware script does not recognise the new card, and as a result does not load the required kernel module.
When you manually load the module, the kernel looks for any devices that can be controlled by that module, and starts controlling the device.
This process will explain how to load the Broadcom module manually, which will then allow the card to work.
Check if Broadcom card has been detected.
Check which modules are currently loaded.
Manually load the Broadcom module.
Check that the Broadcom module is running.
Check that the Broadcom has been detected.
Although you have loaded the Broadcom module and the card is working, you may still have to configure your network connection.
Manually set IP Address.
You should now be able to connect to your ZENworks Imaging server and start imaging.