informtion about switches, we need views

 

Device Name

IP address

model number

serial number

software version

Number of devices in the stack and their details

Devices connected to this switch, for example cisco discovery protocol

Port utilization details

Hardware modules present in the device

 

hi team,

 

please let me know we want report in this format from UD can we get it? What is this hardware module of switch, please expalin.

 

 

 

 

 

Parents Reply Children
  • Cisco provides a broad variety of switches. Therefore there are different options depending on the model you're looking for:


    * Layer2 Topology by Shell Job
      This job reports Layer2 related data for Cisco Nexus 1000, 5000, and 7000 series of switches.

    Discovery Flow
    The discovery flow for the Layer2 Topology by Shell job is as follows:

    1. Get interface details using the command sh int.
    2. Get configured vlans and ports using the command sh vlan all-ports.
    3. Get the list of connected devices using the command sh cdp neighbours detail.
    (see Cisco Nexus Command Reference)

    (From: Discovery and Integrations Content Guide - Discovery Modules
    Chapter 74: Layer2 Discovery)

     

    * CiscoWorks Layer 2 Adapter or

    * CiscoWorks NetDevices Adapter

    Discovered CITs
    - Composition
    - Containment
    - HardwareBoard
    - Interface
    - IpAddress
    - IpSubnet
    - Layer2Connection
    - Membership
    - Node
    - PhysicalPort
    - Realization
    - VLAN

    (From: Universal Discovery Content Guide - Third Party Integrations)

    regards,

    DCV

     

    “HP Support -
    If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.”

    Click the KUDOS star on the left to say 'Thanks'

  • so it meaans we need shell protocol for this, correct? What are the permission required to run such jobs and what are the  prerquistes for such jobs so that i can send sam  to client

  • Hi Ankita,

    The Prerequisites for “Layer2 Topology by Shell Job” are:

    • Set up SSH protocol credentials (more details can be found on p 1089 “Discovery and Integrations Content Guide – Discovery Modules” à Software Version: Content Pack 18.00 (CP18)

    For the CiscoWorks integration the details can be found on: p52/53 “Universal Discovery Content Guide - Third Party Integrations” à Software Version: Content Pack 18.00 (CP18)

    Hope this helps,

    DCV

     

    “HP Support -

    If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.”

     

    Click the KUDOS star on the left to say 'Thanks'