Our vBulletin migration is complete.
Welcome vBulletin users! All content and user information from the Micro Focus Forums (vBulletin) site has been migrated to this site. READ MORE.

Update run status when continuing a run and changing step status

Update run status when continuing a run and changing step status

Sometimes when you continue an existing run you change a step from passed to failed but the run status itself is not updated.

Why is this important, when it would it be used?
The tester may forget to update the run status.

If you were designing the solution, how would  you do it?
Suggest to update run status when continuing manual run and changing step status.

Tags (1)
Arlene Regular Contributor.
Regular Contributor.

This is even more important when retesting defects, so once the impacting defect is retested, the tester should be able to go straight into the failed test run where the defect was raised and pass the failed step - thus increasing the pass rate of the testing according to the reality of defects being fixed and therefore the test now passes the criteria.

Micro Focus Frequent Contributor
Micro Focus Frequent Contributor
Status changed to: Accepted

We're planning to always auto-calculate run status from step status and suite run status from test run status.

The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.