Absent Member.. Absent Member..
Absent Member..

Change the ready to test status in defect.

what is about the “Ready to Test” status?

According to us, it should be displayed under “Not Completed” following the logic 2 as described in your email below


Please let us know if we can change this? And if yes, Could you please send us the all related documents for the changes

3 Replies
Micro Focus Contributor
Micro Focus Contributor



Unfortunately I cannot see the email you are doing reference, but I think maybe someone created a new status. You can check it by going to:


1- Tools

2- Customize

3- Project Lists

4- Status


On the right side, you should see as default:

  • Blocked
  • Failed
  • N/A
  • No Run
  • Not completed
  • Passed

If you can see Ready to Test, is because someone created the new status.


Thank you


Manuel Rivera.

Absent Member.. Absent Member..
Absent Member..



I have added "Ready to test" in the list "Status"

Project Lists -> Status -> Ready to test.


Even though "Ready to test" is the first step, it gets counted as "Passed" in QC. That is its overall status is displayed as "Passed". Users see the overall status as "PASSED" and never realize there is an “READY TO TEST” step left out.


When the test is in "Ready to test" state, the overall status should not be displayed as "Passed".

Please let me know what can be done for this.


Cadet 2nd Class Cadet 2nd Class
Cadet 2nd Class

Can you attch  any screenshots of this issue .




The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.