ArcMC stats gathering - configurable thread/processor count

[ianfitz1]

Hi, when a customer has a lot of connectors, think 300+, it takes some time before stats are gathered by ArcMC. I assume there's a single round robin process that collects from each connector. Can this be made parallel, with parameters exposed for us to tune the level of parallelism so we can get accurate status information within seconds rather than minutes/hours?

Thanks,

Ian.

[dalesio]

Our intent is to build a new Management Center capable of managing and monitoring the entire ArcSight portfolio.  This will include an underlying orchestration engine whereby we can run concurrent workflows on the target systems.

[ianfitz1]

This is also particularly problematic when you restart ArcMC and have to wait for all connectors to be polled a first time before you can control them... Would be great if the "Connectors" tab let you select the last known good connector, rather than requiring the connector to have recently reported in order for you to be able to drill into it...