Highlighted
Honored Contributor.
Honored Contributor.
660 views

Command Line to modify connectors after install

Jump to solution

Hello,

I am trying to modify a connector after installation, I seem to recall there being a gui that you could bring up by navigating to the bin directory and running a command.

The gui displayed a table of values and allowed you change a whole host of properties.

Does anyone know what the command line was and in which document i can find information on it.

It was a smart connector.

Regards

Jack

Labels (1)
0 Likes
1 Solution

Accepted Solutions
Highlighted
Absent Member.
Absent Member.

Hi Jack,

Once you navigate to bin directory type following command:

Windows Platform:

arcsight agentsetup

Linux Platform

./arcsight agentsetup

View solution in original post

0 Likes
2 Replies
Highlighted
Outstanding Contributor.
Outstanding Contributor.

Jack,

Depending on the platform, it' either runagentsetup.bat or runagentsetup.sh

Regards,

Michel

0 Likes
Highlighted
Absent Member.
Absent Member.

Hi Jack,

Once you navigate to bin directory type following command:

Windows Platform:

arcsight agentsetup

Linux Platform

./arcsight agentsetup

View solution in original post

0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.