Highlighted
Absent Member.
Absent Member.
428 views

Do we have a guide for search commands which we use in Arcsight Command Center for investigation?

Hello,

Do we have any guide specific to search commands (SPL as in Splunk) which we use in ACC for investigation?

Can someone share it with me

Labels (1)
0 Likes
3 Replies
Highlighted
Outstanding Contributor.
Outstanding Contributor.

Re: Do we have a guide for search commands which we use in Arcsight Command Center for investigation?

Hi,

You can click on Advanced Search and write your filter condition as you do in ESM console. Please see the attached screenshot.

Regards,

Anirudh

0 Likes
Highlighted
Trusted Contributor.
Trusted Contributor.

Re: Do we have a guide for search commands which we use in Arcsight Command Center for investigation?

ArcSight Logger in Two Hours is a helpful document to get acquainted with the search commands available.  While specifically written for ArcSight Logger, the same operators and syntax apply to ArcSight Command Center.  I've provided a link to the document below.

0 Likes
Highlighted
Acclaimed Contributor.
Acclaimed Contributor.

Re: Do we have a guide for search commands which we use in Arcsight Command Center for investigation?

Hi Vishesh,

It's found in the Command center guide and you can use them to perform some operation while searching similar to SPL on Logger/Splunk  ()

ASA1.JPG

0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.