Highlighted
Super Contributor.
Super Contributor.
628 views

AM Push: The maximum number of active connections (64) has been reached

Hello All,

 

AM 9.40 + Oracle 11g.

 

I have problem with parallel push. The error message is: Error (12,001): The maximum number of active connections (64) has been reached.

 

I reduced parallel.thread.pool.size from 8 to 4 - it did not help.

 

How can I control the number of connections for integration adapters on the data flow probe side?

Best Regards, Sergy.
0 Likes
1 Reply
Highlighted
New Member.

Re: AM Push: The maximum number of active connections (64) has been reached

 Hi Sergy,

 

Sory, i have no idea for how to control the number of connections for integration adapters.

However, regrading to your error, could you please check again the configuration of AM PushAdapter (you can see more details in attachment) and please check enviroment variables for Oracle or adding enviroment variables for Oracle, and increase time out of the job then re-run it.

 

Best Regards,

Hoang.

-------------------------------------------------------------------------------
*HP Support
If you find this or any post resolves your issue, please be sure to mark it as an accepted solution.*
*If you feel the post is helpful, please assign a KUDO star to say "Thanks"*
0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.