Highlighted
Super Contributor.. Super Contributor..
Super Contributor..
160 views

How can i relate CI and Location ??

Hi,

 

I have imported some location and i have discovered some ci also ..

 

I want to relate these location to the corresponding CI by this way :

 - declare range IP in a (new ????) location field

 - if the CI's IP adress correspond to the range of a location, the system will relate it automatically (or i imagine to relate the two attibutes in a view for example) ...

 

Any best practices to do that ?

 

thanks in advance

Labels (1)
0 Likes
1 Reply
Highlighted
Absent Member.. Absent Member..
Absent Member..

Re: How can i relate CI and Location ??

Hello Esposito,

 

Since this requires new/changes in OOTB code, I would suggest to open a case to allow RnD decide if that can be an Enhancement Request or PSO (Proffesional Service Organization) should be involved.

 

Regards,

Juan

"HP Support
If you find this or any post resolves your issue, please be sure to mark it as an accepted solution."
0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.