Honored Contributor.
Honored Contributor.

Network devices discovery - discoveredModel name


UD 10.31 - Cp23

The snmp discovery jobs discovers only the profile name as "Discoveredmodel" or "NodeModel". Is there any job/scipt availble to discover the right modelname of the device? The actual model name is from OID - ( for cisco)..




1 Reply
Outstanding Contributor.. Outstanding Contributor..
Outstanding Contributor..

Re: Network devices discovery - discoveredModel name

Hello James ,

You may add the OID with the correct model at the Normalization Rule . Please use the following document to create a new rule. After that , please run the job and open a case if you receive any error.


Best Regards,

Melissa Carranza Mejias
Customer Support Engineer

If you find that this or any other post resolves your issue, please be sure to mark it as an accepted solution.
If you are satisfied with anyone’s response please remember to give them a KUDOS by clicking on the STAR at the bottom left of the post and show your appreciation. “
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.