Micro Focus Expert
Micro Focus Expert

(UCMDB) Support Tip: - Vcenter discovery errors

In the event VCenters are being discovered perfectly, but for some reason it start to fail due to empty value of IP Address.


Please note in vmware_vim.base.py there was a code change. This change was done during the implementation of a previous CP.


To fix such discrepancy, one should perform a code change manually in the Adaptor Management as follow:


Go to original file _vmware_vim_20.py of CP19. 

Add  two lines codes below around line 428. (It appears when one try to get portgroup, it returned nothing, and it requires an empty value at first)


self._portGroupPorts_Mac_PG= {}

self._portGroupPorts_Mac_Vswitch = {}


Then Clean probe cache and rerun job.


If any issues while arrise while performing these changes, please open a Support ticket. Thank you.

MICRO FOCUS Software Support
If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.
Please hit the Kudo botton, if you find this post useful.
Tags (1)
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.