Micro Focus Frequent Contributor
Micro Focus Frequent Contributor
227 views

UCMDB Tip: Job status is ‘reached probe’ for a long time

If you come across an issue where job status is ‘reached probe’ for a long time, please try the following:

 

  • Start from probe JMX:
    • Jobs Information – view job statuses.
    • If the job is not finished yet:

             - Check the logs – is probe loaded?

             - Is blackout policy defined for the probe?

             - Check WrapperProbeGW.log:

                      Job is blocked due to blackout policy

             - Scheduling: The status of the job is set to ‘in progress’ once the trigger arrives to the probe. As a result, if the   job is defined with future start time, the status will be in progress until then.

  • Please note that until v.10.01, the status was ‘in progress’ (instead of ‘reached probe’).
“HP Support
If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.”

Click the KUDOS star on the left to say 'Thanks'
Labels (1)
Tags (1)
0 Likes
0 Replies
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.