UCMDB integration with NNMi and Network Automation


Have anyone work with integration between UCMDB - NNMi and UCMDB - NA ?

When I run integration between UCMDB and NNMi only, it was running fine. I apply some customization code in nnmi.py and nnm_api.py to get the custom attribute from NNMi. All running fine, until I apply the integration with NA.

The behaviour from NA integration, it updates some attributes from NNMi, including CI Type.

My question is, what is the best practice if we have these 2 integration in place ? Which integration should run first (UCMDB - NA) or (UCMDB-NNMi) ?
How should we apply the sync priority ? From NA, I need only the serialnumber information populated to UCMDB CIs, but not updating the other attributes.

Anyone can advise how to achieve that ?

Thanks in advance,


1 Reply
Outstanding Contributor.. Outstanding Contributor..
Outstanding Contributor..

Re: UCMDB integration with NNMi and Network Automation

Hello ,

You can test the integration UCMDB-NNMI and then NNMI-NA.

Best Regards,

Melissa Carranza Mejias
Customer Support Engineer

If you find that this or any other post resolves your issue, please be sure to mark it as an accepted solution.
If you are satisfied with anyone’s response please remember to give them a KUDOS by clicking on the STAR at the bottom left of the post and show your appreciation. “
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.