Highlighted
Absent Member.. Absent Member..
Absent Member..
110 views

UD agent- software utilization component

Hi,

 

Working on UD 10.2 with latest CP and CUP.

 

I have installed agent on desktops with NTCMD  but forgot to install software utilization component . Is there any way to reinstall the agent with software Utilization  'ON'.

 

 

It is very urgent and expecting response asap.

 

Regards,

Nick

0 Likes
1 Reply
Highlighted
Outstanding Contributor.. Outstanding Contributor..
Outstanding Contributor..

Re: UD agent- software utilization component

Hello Nick ,

 

I hope you are doing well .

 

I found this information in the DDMi to UCMDB Discovery Migration :

 

"SOFTWAREUTILIZATION Enable or disable Software Utilization plug in.
Use "ON" to enable and "OFF" to disable.
Default is "OFF"."

 

 

Best Regards ,

Melissa Carranza Mejias
Customer Support Engineer

If you find that this or any other post resolves your issue, please be sure to mark it as an accepted solution.
If you are satisfied with anyone’s response please remember to give them a KUDOS by clicking on the STAR at the bottom left of the post and show your appreciation. “
0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.