Visualize - "Unable to load user preferences" error

Visualize - "Unable to load user preferences" error

The issue is caused by users being created after the mpx server had been stopped.
Try the following to check if this issue occurs with a new user.

Stop the CaliberRM Server (Open command prompt - enter "dbmgr -stop" to stop the database manager)

You can perform the steps below from the Windows services menu ( Start > Type "Services").

Please stop the following services in this order:

  1. Caliber Visualize
  2. SQM Database,
  3. SQM Monitor,
  4. StarTeam Message Broker,
  5. StarTeam Multicast Service (if used & started)

Then restart in the following order:

  1. SQM Database,
  2. SQM Monitor,
  3. StarTeam Message Broker,
  4. StarTeam Multicast Service (if used),
  5. CaliberRM Server (Open command prompt - enter "dbmgr -start" to start the database manager
  6. Caliber Visualize

Try to create a new user in Caliber Administrator. Check to see if it can connect

Try with the previous user you had issues with.

All users should now be synchronised with Visualize and Caliber.

SI:2810361
SI:2648729
SI:2638762

DISCLAIMER:

Some content on Community Tips & Information pages is not officially supported by Micro Focus. Please refer to our Terms of Use for more detail.
Version history
Revision #:
1 of 1
Last update:
‎2015-04-29 11:18
Updated by:
 
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.