bbeaverson Absent Member.
Absent Member.
1315 views

Reporting only those requirements that have changed since a baseline was set.

One of our BAs was wondering if there is a way to report just those requirements in CaliberRM (v 10.1) which have been added or modified since a baseline was set. It looks as though you can use the diff function in Document Factory when comparing two different baselines, but can you do the same without setting another baseline first?

0 Likes
1 Reply
RobinM1 Absent Member.
Absent Member.

RE: Reporting only those requirements that have changed since a baseline was set.

Hi,

Currently the comparison must be done between two specific baselines. It might be possible to pull out the  information via a Datamart extract or the SDK but I would need to do some further investigation. If this is something you would like us to explorer further, please log a support incident.

Kind regards,

Robin

0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.