Micro Focus Contributor
Micro Focus Contributor
1047 views

How does CO calculate the capacity planning ?

Do we have an document in Cloud optimizer which describes about calculations and formulas CO uses for capacity planning. I am unable to find it in Standard documentation set which is  shipped with..

0 Likes
3 Replies
Highlighted
Micro Focus Expert
Micro Focus Expert

Re: How does CO calculate the capacity planning ?

Hello Sakul,

You ask a very good question.

The details of the calculations is not contained within the official product documentation.  It would be a good enhancement request to have that information available.

There was a community blog that was written a few years ago that may answer your question.

How to use Virtualization Performance Viewer to solve resource sprawl
https://community.softwaregrp.com/t5/IT-Operations-Management-ITOM/How-to-use-Virtualization-Performance-Viewer-to-solve-resource/ba-p/277197

Please review this information and see if it answers your question.  If it does not, then it may be necessary to open an official support case to get the correct answer.

I hope that this is helpful.

Regards,

Mark

---
Mark Butler
Micro Focus SW Support Engineer
https://softwaresupport.softwaregrp.com/
Tags (3)
0 Likes
Aaron Laing Outstanding Contributor.
Outstanding Contributor.

Re: How does CO calculate the capacity planning ?

The article link you referenced comes back as "Access Denied" for me.  I certainly have an SAID on my profile with most, if not all, of the OpsBridge products on it, so is the link broken?

If you could re-post the original content here, or there is an updated link, that would be great, as I too would like to know more about how the various CO values are calculated.

Thanks,
Aaron

0 Likes
Micro Focus Expert
Micro Focus Expert

Re: How does CO calculate the capacity planning ?

Hello Aaron,

Yes, I know that there have been problems in the past being able to access this blog post.

I just accessed it and was able to view it.

I have taken the contents of the blog post, updated references from vPV to CO and turned it into a PDF file that I'm attaching to this post.

In addition, this information is contained within the following knowledge article on the MySupport portal.  I'll be adding a CO Support Tip reference to this document later.

https://softwaresupport.softwaregrp.com/km/KM03200873

I hope that this helps answer your question.

Regards,

Mark

---
Mark Butler
Micro Focus SW Support Engineer
https://softwaresupport.softwaregrp.com/
0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.