ksognovell Absent Member.
Absent Member.
390 views

HP Prodesk 600 G3 freezes after image

Hello,
with 11.4.3 imaging is no Problem
on ower new HP Prodesk 600 G3.
But: after writing the image, the image-engine
tries to do a reboot and the machines freezes.
One has to press the powerbutton to reanimate
the PC.
In Maintanance-Mode I tried the bash-command
reboot => same behaviour!

In Maintanance-Mode I tried the bash-command
shutdown -R
then only the folowing error-message appears:
Failed to set wall message, ignoring: Failed to execute program org.freedesktop.login1: Success
Failed to call ScheduleShutdown in logind, proceeding with
immediate shutdown: Failed to execute program org.freedesktop.login1: Success


Nothing else happens and the bashprompt returns. :mad:

Tried several BIOS-settings and BIOS-Updates.
On our older maschines erverything works fine.

Anybody any ideas?

Tank you and best regards
Martin
Labels (1)
0 Likes
1 Reply
AutomaticReply Absent Member.
Absent Member.

Re: HP Prodesk 600 G3 freezes after image

ksognovell,

It appears that in the past few days you have not received a response to your
posting. That concerns us, and has triggered this automated reply.

These forums are peer-to-peer, best effort, volunteer run and that if your issue
is urgent or not getting a response, you might try one of the following options:

- Visit https://www.microfocus.com/support-and-services and search the knowledgebase and/or check
all the other self support options and support programs available.
- Open a service request: https://www.microfocus.com/support
- You could also try posting your message again. Make sure it is posted in the
correct newsgroup. (http://forums.microfocus.com)
- You might consider hiring a local partner to assist you.
https://www.partnernetprogram.com/partnerfinder/find.html

Be sure to read the forum FAQ about what to expect in the way of responses:
http://forums.microfocus.com/faq.php

Sometimes this automatic posting will alert someone that can respond.

If this is a reply to a duplicate posting or otherwise posted in error, please
ignore and accept our apologies and rest assured we will issue a stern reprimand
to our posting bot.

Good luck!

Your Micro Focus Forums Team
http://forums.microfocus.com



0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.