Murzda Absent Member.
Absent Member.
2679 views

How do you change the default port 2950 for remote control?

I need to test remote control through a VPN connection using a different port for remote control than 2950 on the server side. How is this done?

Our network router folks will not open up this port on the firewall until we test using an existing open port.

Thanks in advance.

Chris

Labels (2)
0 Likes
3 Replies
shaunpond Absent Member.
Absent Member.

Re: How do you change the default port 2950 for remote control?

Murzda,

does the documentation help? http://www.novell.com/documentation/zcm10/zcm10_remote/data/bab3ncx.html

--

Shaun Pond


0 Likes
Murzda Absent Member.
Absent Member.

Re: How do you change the default port 2950 for remote contr

spond;1707797 wrote:
Murzda,

does the documentation help? Novell Doc: ZENworks 10 Configuration Management Remote Management Reference - Configuring the Remote Management Settings

--

Shaun Pond


Thanks Shaun. That's what I was looking for.

Chris

0 Likes
shaunpond Absent Member.
Absent Member.

Re: How do you change the default port 2950 for remote control?

Murzda,

great 🙂

--

Shaun Pond


0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.