Ayman D. Jweina Absent Member.
Absent Member.

Data Protector 6.0 with LTO Tape Media Encryption Failure

Hello All
i had MSL 6030 with 2 FC LTO2 Tape Drives , recently i had upgrade this MSL with 2 x LTO4 Tape Drives in order to manage backup size and window , and so i upgrade the firmware of the MSL NSR and Tape Drives to the latest through L&TT ...

Backup worked fine and MSL identified the two new drives as required . but when try to configure Hardware Encryption for the backup .
i faced a message show that encryption is enabled but deice is not supported
paramters adjusted in omnirc file are:-

Please advice what is needed since the two drive is LTO4 tape Drives and all media used is LTO4 800/1600 tape media
Output of the Encryption runing:-
[Normal] From: VBDA@sma-dr.automation.com "C:" Time: 8/20/2009 1:53:08 PM

STARTING Disk Agent for sma-dr.automation.com:/C "C:".

[Critical] From: BMA@sma-dr.automation.com "HP:Ultrium 4-SCSI_1" Time: 8/20/2009 1:53:13 PM

[90:6114] Drive-based encryption is enabled but the device does not support encryption, aborting session.

[Critical] From: VBDA@sma-dr.automation.com "C:" Time: 8/20/2009 1:53:13 PM

Unexpected close reading NET message => aborting.

[Critical] From: VBDA@sma-dr.automation.com "C:" Time: 8/20/2009 1:53:13 PM

Connection to Media Agent broken => aborting.

i will mark this case with a high points ratio

Ayman Jweinat
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.