Regular Contributor.. Regular Contributor..
Regular Contributor..
83 views

this message occurred like "cannot read 20bytes at offset -20(:30): ([50] request not support)"

hello i'm haesu 

we are backup nas by data protector 7

this message occurred like "cannot read 20bytes at offset -20(:30): ([50] request not support)" during backup

but backup working is complete 

so i want know about this message 

and i was check filesystem about nas disk 

however disk status is good 

so can tell me about  this message?

 

0 Likes
1 Reply
Highlighted
Micro Focus Expert
Micro Focus Expert

Re: this message occurred like "cannot read 20bytes at offset -20(:30): ([50] request not suppo

Hello @djgotn89

What NAS device are you using? Is this one supported in DP 7?
https://softwaresupport.softwaregrp.com/doc/KM1357659

Regards, 

Andres Fallas Salazar
Customer Support Engineer

If you find that this or any other post resolves your issue, please be sure to mark it as an accepted solution.
If you are satisfied with anyone’s response please remember to give them a LIKE by clicking on the bottom at the left of the post and show your appreciation.
0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.