Welcome Serena Central users! CLICK HERE
The migration of the Serena Central community is currently underway. Be sure to read THIS MESSAGE to get your new login set up to access your account.
Doc Trusted Contributor.
Trusted Contributor.
301 views

10.2.1 Program Sections problem

Has anyone run into a problem with 10.2.1 programs using "sections". I can compile on version 10.0.1 and the program works fine. I compile the same program with 10.2.1 and it "Falls Thru"  past the next section and crashs. I took out all "sections" and changed to xxxx thru xxxx-exit.  exit and it works fine..  

0 Likes
2 Replies
Micro Focus Contributor
Micro Focus Contributor

Re: 10.2.1 Program Sections problem

If you can write a small program that shows this behavior, you should contact Support to raise an RPI. This sounds serious, and should be investigated!

0 Likes
Doc Trusted Contributor.
Trusted Contributor.

Re: 10.2.1 Program Sections problem

I will take out all the files ETC. and make a small program from the existing one and test to make sure it still fails and will then send it in for evaluation ETC. This might take me a week or so.

 

0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.