Highlighted
New Member.
1360 views

Abort was called from an action

Hi,

    For SAP application While executing in controller,  We are facing the stopped status.

 

Error message :" Abort was called from an action "

 

Kindly do the Needful ASAP.

 

LR 11.0  and SAP 6.0 

SAPGUI protocol

Tags (1)
0 Likes
4 Replies
Highlighted
Absent Member.
Absent Member.

Re: Abort was called from an action

There are errors that preceed that Abort, you would need to check those, probably something was not done while replaying. And since its in the Controller it could be that amount of users ran.

 

Regards,

Mario M.

HP LR/PC Support

If you are customer you can try posting on our internal forums for more personalized support.

LoadRunner:
http://h30499.www3.hp.com/t5/LoadRunner-Support-Customer/bd-p/loadrunner-support-customer-forum

Performance Center:
http://h30499.www3.hp.com/t5/Performance-Center-Support/bd-p/performance-center-support-customer

How to:
http://www.youtube.com/watch?v=4ChlysWupWM

If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.
0 Likes
Highlighted
New Member.

Re: Abort was called from an action

normally script replay issues which contribute to this.

Do you have any more details on what preceeded this event?

Did you script replay fine on VUGEN for multiple data sets?

Identify the particular virtual user from analysis, use the error graph and filter by / drill down by Vuser ID should be able to give you some details. (assuming logs were not turned off).

 

if the logs were turned off, i suggest you re run with extended logs turned on.

 

Regards,

AJ

 

 

0 Likes
Highlighted
New Member.

Re: Abort was called from an action

Hi,

    Thanks for your reply, I have executed with multiple iteration.

It was working fine.

While executing in controller its not working.

Kindly do the needful.

 

 

 

0 Likes
Highlighted
New Member.

Re: Abort was called from an action

Hi,

    I am getting any error message, When ever users are ramping down its going to stopped status.

I given setting in Controller,

 

Wait for the current iteration to end before stopping.

 

Regards,

Chitra

0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.