Highlighted
Absent Member.
Absent Member.
139 views

Analysing and running loadrunner for application to be started with batch files

Hi Everyone,

I want to analyse loadrunner for an application which start with a bat file however when I want to use protocol advisor, it asks for an exe file. There is no option for batch file there. So, does anyone have any idea about what should be done in order to analyse and then record the user actions on that application?

thanks a lot..
0 Likes
2 Replies
Highlighted
Acclaimed Contributor.
Acclaimed Contributor.

Re: Analysing and running loadrunner for application to be started with batch files

Select "All Files" in file type, and select your batch file. It can launch
0 Likes
Highlighted
Absent Member.
Absent Member.

Re: Analysing and running loadrunner for application to be started with batch files

thanks for the reply...
I selected .bat file in loadrunner to start the application but the application was not started. Instead it gave an error message.
The error message can be seen it:
http://www.kgaurav.com/temp/lrerror.png

The messages in command prompt can be see at:
http://www.kgaurav.com/temp/lrerror1.png

Please advise me something over this... I have tried much but I don't know what is wrong..

thanks a lot,
Kumar
0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.