Highlighted
Absent Member.
Absent Member.
257 views

Diagnostics - Configure button is greyed out.

PC 9.5.1

Diagnostics 8.0

Diag Server, Diag Collector (for SAP R/3 data), PC 9.5.1 Server, Host components all on same Win2k3 sp2 machine.

 

Creating new load test, configuring diagnostics ...the Offline & Online Diagnostics secsion, the J2EE/.NET Diagnostics "Configure" button is greyed out.  When using LoadRunner, this is where I would go in the Controller to select the registered probe so the Collector could collect R/3 data.  But, using Performance Center, this button is greyed out.

 

I've tried all documented suggestions:  PC Admin pages: setup all Diagnostics Server info, double checked Admin privileges, etc.

 

Note: Diag server and collector WORK FINE in standalone mode (via Browser).  Just trying to configure Diag to work with Performance Center.  Document says the LR Add-in is NOT needed for Performance Center.

 

SCREENSHOT of greyed out button attached.

0 Likes
1 Reply
Highlighted
Acclaimed Contributor.
Acclaimed Contributor.

Re: Diagnostics - Configure button is greyed out.

Did you enter your Diagnostics Server details in the PC Admin site?

0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.