New Member.

Flex protocol Recording.



Am new to working on a FLEx application. Please tell me about the Recording options followed, Correlation Procedure, Runtime settings.


let me also know about the pre quiste required for FLEX application scripting like JAR FILES inclusion.


hope tis will give me an rough idea to proceed further. Kindly reply ASAP.

1 Reply
Super Contributor.
Super Contributor.

Re: Flex protocol Recording.

Hello Antony,
I would like to suggest you to check the HP VuGen Guide that comes with the LoadRunner/Performance Center Product (which you can also get from here). There is a section for FLEX introduction and a special section for FLEX Correlation. You can find all the information you have requested in it.

If you face a specific recording issue, I would suggest you to check the knowledge base first and then proceed to open a ticket with us for further analysis.

Hope you find what you are looking for.

HP Support

If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.