Highlighted
Knowledge Partner Knowledge Partner
Knowledge Partner
1789 views

Load Generators/Controller Status is turned to non operational after running a load test.

Hi All,

 

Can any one please advise me on the below problem.

 

When testers are excecuting SAP GUI tests on the load generators from the controller , the LG's and controller are switching to non operational state.

 

 Regards,

Srihari

 

Tags (1)
0 Likes
2 Replies
Highlighted
Absent Member.
Absent Member.

Re: Load Generators/Controller Status is turned to non operational after running a load test.

Hi Srihari,

 

Do you any details for errors when executing this script? What version of Vugen and SAP server are you using?

 

Regards,

Mario M.

HP LR/PC Support

If you are customer you can try posting on our internal forums for more personalized support.

LoadRunner:
http://h30499.www3.hp.com/t5/LoadRunner-Support-Customer/bd-p/loadrunner-support-customer-forum

Performance Center:
http://h30499.www3.hp.com/t5/Performance-Center-Support/bd-p/performance-center-support-customer

How to:
http://www.youtube.com/watch?v=4ChlysWupWM

If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.
0 Likes
Highlighted
Absent Member.. Absent Member..
Absent Member..

Re: Load Generators/Controller Status is turned to non operational after running a load test.

Is this something that is easily reproduced or is it something that happens randomly?  If it happens all the time I would suggest putting the hosts that are going into the non-operational state after running a load test in Debug mode and reviewing the logs for error messages.

 

You don't want to leave the hosts in debug mode for extended periods of time however because it can have a negative effect on the results that you collect so if this is something that is happening randomly you may want to take some of the hosts out of normal use, put them in a special debugging Host Pool and then put them in Debug mode and run several tests, clearing the debug logs between tests until you can reproduce the problem.

 

Is this happening only on the host that is the Controller or is it also happening on hosts that are Load Generators and Stand Alone Load Generators?

 

Will PC recover the host back to Available state after 15 - 30 minutes?

 

Can this be reproduced with a single user test or does it only happen after an extended run?

 

When you have some of this additional information or if you are not able to determine an answer for these questions you should consider opening a support case on the Software Support Web site.

 

C Drummond

 

0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.