Highlighted
Absent Member.
Absent Member.
91 views

LoadGenerator STOPs participating in scenario

I have a strange behavior where one of our load generators runs okay for the 1st 8-10 minutes of the scenario-test, and at that point it stops running/participating in the scenario. This is a scenario that was running okay for the past 1-month with that same load generator.
I have tried all of the following: reboot load-generator; re-create the scenario; re-install the software on the LG server.
I have also checked that the service is running okay while this is happening, and have run 'netstat –bav' to make sure the ports are active.

Any idea what is the cause?

Thanks,
Ayelet.
0 Likes
1 Reply
Highlighted
Absent Member.. Absent Member..
Absent Member..

Re: LoadGenerator STOPs participating in scenario

1. Go to %temp% on the Load Generator and clear out that directory. Try the scenario again.

Actually, there is no number 2... I think number 1 is your problem.
0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.