Highlighted
Absent Member.
Absent Member.
52 views

LoadRunner 9.52 parameter Q

10 IDs (muliple sessions ok) parameterized for script that is running over a set amount of time. Some of the scenarios, require a load of 25 or more vusers.

Which is working for you with the parameter list?
1. Table with just the 10 ids, run sequentially
2. Replicate the 10 ids, to provide more ids, if needed.
3. Have greater amount of unique ids.

Then do you select to run them sequentially or unique?

I have created a table of just the 10 ids, sequential. Have verified I can run a burst of all ids to completion without error; however, when running script for 5 minutes, and scenario only starts 1 id every 4 seconds, errors occur. Suggestions?
0 Likes
1 Reply
Highlighted
Super Contributor.
Super Contributor.

Re: LoadRunner 9.52 parameter Q

check simulate parameter option when you select sequential...only the first 1 id will be used for all the iterations...instead use unique and then check..now it will pick different id's
0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.