Highlighted
Contributor.. Contributor..
Contributor..
267 views

Pef Gen Server - IP Wizard - Unable to add/remove new IPs

 

 We recently issued new IPs for the IP- Spoofing feature of Performance Cetner version 12.50. Previously, about 30 different IPs were successfully added using IP Wizard feature. We had conducted numerous performance tests with these IPs.  Recently, those IPs had to be replaced with a set of newly created IP addresses created by our network team.  

We encountered issuss in deleting the IPs using the IP-Wizard feature.  Bascially, everytime we would deltete an IP, it would show up again upon re lauching the IP-wizard to reomve additional IP addresses.  As a result, we contancted HP, and as advised with deleted the old IPs mannually from the registry folder location. This helped us get rid of the old Ips, but created a new problem where the new added IPs get blanked out once we relaunch the IP Wizard.  HP suggested that we have Admin rights in the machine and we have confirmed that do have that privilege.  

This was never the case when we first used the IP Wizard feature to add and remove IPs. The only thing that changed recently is that we changed the name and IP of the PERF Gen server.

Please see the attached for details.

Your input will be appreciated.

 

Thank you

0 Likes
2 Replies
Highlighted
Acclaimed Contributor.
Acclaimed Contributor.

Re: Pef Gen Server - IP Wizard - Unable to add/remove new IPs

Hello bola1234,

Thank you for your post.

Could you please go to the this registry key:

HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Tcpip\Parameters\Interfaces and check on the IPAdress and review which IP addresses you have in there? are the old ones?

Regards,

Daniela Gómez Alvarado
Customer Support Engineer

If you find that this or any other post resolves your issue, please be sure to mark it as an accepted solution.
If you are satisfied with anyone’s response please remember to give them a KUDOS by clicking on the STAR at the bottom left of the post and show your appreciation.
0 Likes
Highlighted
Contributor.. Contributor..
Contributor..

Re: Pef Gen Server - IP Wizard - Unable to add/remove new IPs

Hi Daniela,

Upon going to the Registry, we can only see the IP address of the server itself.

Thanks.

0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.