Highlighted
Absent Member.. Absent Member..
Absent Member..
206 views

Different analysis result

Hello,

I have problem load runner analysis tool. The results are different i dont understand. i upload the picture.

responses are different why ?

but i have another analysis result and the values is close.

for example

getmypolicyremainglimit            maximum 43.086 sec      and     on the graph 0.735 sec ? ?

 

 

0 Likes
1 Reply
Highlighted
Absent Member.
Absent Member.

Hi,

 

The values that you see on the garph is "Grap's Maximum" and they calculated based on granularity of the graph (so if you'll change granularity, this values will change as well).
To see the exact values please Right-click on Legend -> Configure Columns -> add "Maximum", "Average" and "Minimum" checkboxes.

 

Regards,

Mikhail

0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.