Highlighted
Super Contributor.. Super Contributor..
Super Contributor..
108 views

LoadRunner results Analysis is only showing the ramp up data

Not sure what happen but recently we are experiencing an issue with our results data.  The test is setup for an hour and after the test completed we are only seeing data for the ramp-up portion.  I have check the .lrr file (see below).  When opening analysis it only show 5 min and 12 seconds.  All charts show the same time.

[Scenario]
Product=LoadRunner Controller
Version=12.63.0.0
Path=Scenario1
Subject=
Description=
ResultName=res1306
Time_Zone=28800
Start_time=1597307853
Daylight_Bias=-60
Stop_time=1597309810

 
Boatnlarry
0 Likes
0 Replies
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.