LoadRunner scripting and SSRS Report Builder
I am recording a script to perfromance-test a couple of reports in SSRS Report Builder, but having issues correlating it.
I recorded a couple of two identical scripts to find out which values were dynamic and I correalted these two:
SessionKeepAlive&ControlID=[Session correlated value] and Body=[body correlated value].
This worked for about an hour, but after that it started giving me this error in the live viewer:
'The report execution [body correlated value] has expired or cannot be found.'
It gives me error 500 in the log.
What am I doing wrong and is there something special about recording scripts in Report Builder? I am using LR 11.52 and tried it in 12.0 with the same results.
Re: LoadRunner scripting and SSRS Report Builder
What protocol that you used to record the script?
Could you please share the screenshot of error?
It will be helpful if you can share the script with full extended log or you can share the recording log that include the dynamic value - Body.
Chau Nguyen | SW Technical Support Consultant.
LoadRunner and Performance Center
If you find that this or any other post resolves your issue, please be sure to mark it as an accepted solution.
If you are satisfied with anyone’s response please remember to give them a KUDOS by clicking on the STAR at the bottom left of the post and show your appreciation.