I am receiving an error in the Controller regarding the fact that I am exceeding the number of Vusers. I have a license set for 2500, but there is also the basic License of 50 on there. I only receive this error when I reach 50 vusers.
Is there a way to remove the basic License of 50, or a way to set to only use the License with 2500?
I could not find the REGEDT location of the Licenses. The License Utility says I have the 2500 activated, but I cannot run a load test with more than 50 vusers.
T6234AAE HP LRner Cntlr & Monitors SW E-LTU 1
TC967AAE HP LR Web/Mmed 100-499 VU SW E-LTU 100
TC964AAE HP LR Web/Mmed 500-4999 VU SW E-LTU 2.400
TB141AAE HP LR/PC Diag for Comp AppInst SW E-LTU 16
I am currently using LR 11.52. Any help would be great.
Re: Loadrunner License
I was checking the information provided, and I would like to know what is the protocol of the scripts that you are testing since I noticed that your licenses are Web&Multimedia.
Joel Aguilar Cerna
SW Support Technical Consultant
San Jose, Costa Rica
If you find that this or any other post resolves your issue, please be sure to mark it as an accepted solution.
If you are satisfied with anyone’s response please remember to give them a KUDOS by clicking on the STAR at the bottom left of the post and show your appreciation.