Idea ID 2850423
Adding OOB policies to enable polling in NNM or in IPT SPI to monitoring following metrics. At this moment we have setup custom pollers to monitor SPI Trunk Status and Trunk Utilization
2.4.2 SIP Trunk Status
SIP trunk status is an important element of CUBE monitoring. This status is not currently available via SNMP (only via CLI as covered in the previous section).
However, there are MIBS that can be used for monitoring active calls. See the chart below. Are these MIBs available in NNMi?
Table 5. CISCO IOS MIBs that Contain Active Call Information
MIB OID Table Name Number of Entries per Call
DIAL-CONTROL-MIB 126.96.36.199.188.8.131.52 callActiveTable 2
CISCO-VOICE-COMMON-DIAL-CONTROL-MIB 184.108.40.206.220.127.116.11.55 cvCommonDcCallActiveTable 2
CISCO-VOICE-DIAL-CONTROL-MIB 18.104.22.168.22.214.171.124.63 cvCallActiveTable 0 (Used for TDM GW calls only)
CISCO-VOICE-DIAL-CONTROL-MIB 126.96.36.199.188.8.131.52.63 cvVoIPCallActiveTable 2
Table 8. Real-Time Trunk Utilization: CISCO-VOICE-DIAL-CONTROL-MIB
OID OID# New/Changed Platform Use/Operation cvVoIPCallActiveTable
184.108.40.206.220.127.116.11.18.104.22.168 Baseline ISR G1, ISR G2, AS5x00, ASR Provides statistics on active VoIP calls, indexed by callActiveSetupTime and callActiveIndex.
cvCallVolume 22.214.171.124.126.96.36.199.188.8.131.52 CUBE 1.4 ISR G1, ISR G2, AS5x00
Total, per-protocol, per-dial-peer and per-interface call active statistics.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.