Highlighted
Absent Member.. ruleung Absent Member..
Absent Member..
1758 views

Adding topology with command loadhosts but return object is unknown

Jump to solution

Do any one have idea of this error?

 

While I am using the command loadhosts to add the following topology, the command the following error.

 

Adding Topology of swx03ntcs(10.49.3.210)...
        1) Created swx03ntcs (id = 789938)
        1) Added 10.49.3.210 (id = 789939) to swx03ntcs
ERROR: Could not add node swx03ntcs to topology: Requested object is unknown
Adding Topology of swx03ntcs(10.49.3.210) - FAILED!!!

 

The node can snmpwalk and nslookup normally. We are using NNM 7.53 and OMU 8.35.202. Thanks.

0 Likes
1 Solution

Accepted Solutions
Micro Focus Expert
Micro Focus Expert

Re: Adding topology with command loadhosts but return object is unknown

Jump to solution

Hello.

Please, check out the KCS doco http://support.openview.hp.com/selfsolve/document/KM109050.

 

You need to supply correct mask with loadhosts command. Like:

 

loadhosts -v -m <netmask> -c <IP address> -n 1

 

And also netmon should be stopped before you use loadhosts. So, preferred is using "netmon -h <IP>" if you run NNM 7.53.

To make use of this command, netmon auto-discovery has to be tuned on.

Mikayel Grigoryan
HPE Software

If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.
2 Replies
Micro Focus Expert
Micro Focus Expert

Re: Adding topology with command loadhosts but return object is unknown

Jump to solution

Hello.

Please, check out the KCS doco http://support.openview.hp.com/selfsolve/document/KM109050.

 

You need to supply correct mask with loadhosts command. Like:

 

loadhosts -v -m <netmask> -c <IP address> -n 1

 

And also netmon should be stopped before you use loadhosts. So, preferred is using "netmon -h <IP>" if you run NNM 7.53.

To make use of this command, netmon auto-discovery has to be tuned on.

Mikayel Grigoryan
HPE Software

If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.
Absent Member.. ruleung Absent Member..
Absent Member..

Re: Adding topology with command loadhosts but return object is unknown

Jump to solution

Hi Mikayel Grigoryan,

 

The solution work!. I have six problem node also can be solved by this solution. Thank you very much.

0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.