Highlighted
Captain
Captain
485 views

Custom Attributes in Interface and Node Forms

Hello,

 

We want to add Custom Attributes in Interface and Nodes Form for proper grouping of Interfaces and Nodes managed in NNMi.

 

Please let us know are there any limitations for creation of number of Custom Attributes and also  can these custom attribute values be passed in Interface or Node Down Incidents.

 

Thanks & Regards.

 

 

 

0 Likes
4 Replies
Highlighted
Absent Member.
Absent Member.

Hello Ganeshaym,

 

Tomorrow I will be letting you know the best practice for this request.

 

J.Vindas,

HP Support,

The views expressed in my contributions are my own and do not necessarily reflect the views and strategy of HP. If you find this or any post resolves your issue, please be sure to mark it as an accepted solution,If you are satisfied with anyone’s response please remember to give them a KUDOS and show your appreciation.
0 Likes
Highlighted
Absent Member.
Absent Member.

Hello Ganeshaym,

 

The best practice for this request, is creating the or using into the Node or Interface group, basically the same thing, you just need to create an additional filter tab into the node or interface group when you create it.

 

Otherwise, if you have the node or interface gropu created, you just need to open, and in the same way, add an additional filters, then you just need to wait when the group just take the nodes based on the Custom Atrubutes that you set.

 

Regarding the question about a limit, in my experience I never heard about a limit to create custom atributes. Last about if can these custom attribute values be passed in Interface or Node Down Incidents, I will be investing time about it and as a soon as I have any information I will be leeting you know.

 

J.Vindas

HP Support,

The views expressed in my contributions are my own and do not necessarily reflect the views and strategy of HP. If you find this or any post resolves your issue, please be sure to mark it as an accepted solution,If you are satisfied with anyone’s response please remember to give them a KUDOS and show your appreciation.
0 Likes
Highlighted
Captain
Captain

Hi,

 

Thanks for the reply.

 

Yes would appreciate if you could let us know the possibility of including the custom attributes in Interface and Node Down Incidents.

 

Thanks & Regards.....

0 Likes
Highlighted
Absent Member.
Absent Member.

Hello Ganeshaym,

 

Investing time about it, with custom attributes basically you need to enrich the trap by adding them from the node or interface to the incident.

 
So edit the Node Down trap, go to enrichment, and then specify the CAs you want to add, this is the way to achieve it.
 
J.Vindas
HP Support,

The views expressed in my contributions are my own and do not necessarily reflect the views and strategy of HP. If you find this or any post resolves your issue, please be sure to mark it as an accepted solution,If you are satisfied with anyone’s response please remember to give them a KUDOS and show your appreciation.
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.