Highlighted
Acclaimed Contributor.
Acclaimed Contributor.
315 views

Interface In and out utilizationinterface in and out utilization

Dear All

How does NNMi collects Interface In and Out utilization. Does it uses any MIB variable and which calculation it uses to collect In and Out utilization.

0 Likes
2 Replies
Highlighted
Trusted Contributor.
Trusted Contributor.

Re: Interface In and out utilizationinterface in and out utilization

Hello, to answer your question you can check the following document with a more detailed information about it. Utilization, Error Rate or Discard Rate shown as unavailable for an interface: https://softwaresupport.softwaregrp.com/group/softwaresupport/search-result/-/facetsearch/document/KM771326 hope this helps to answer your question.

Gwendolyne Maroto Artavia
Customer Support Engineer

If you find that this or any other post resolves your issue, please be sure to mark it as an accepted solution.
If you are satisfied with anyone’s response please remember to give them a KUDOS by clicking on the STAR at the bottom left of the post and show your appreciation. “
Highlighted
Acclaimed Contributor.
Acclaimed Contributor.

Re: Interface In and out utilizationinterface in and out utilization

Hi

I see KM document is applicable for NNM versions upto 8.10

Please clarify whether it is applicable for later NNM versions as well.

0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.