Highlighted
Acclaimed Contributor.
Acclaimed Contributor.
295 views

Monitor non snmp nodes using ICMP

Jump to solution

NNM 10.40

We have few non snmp nodes discovered in NNMi and we had configured below montioring,

Enable Management Address Polling
Enable IP Address Fault Polling

When Ping is not responding, please let us know which NNMi management incidents we will receive.

We had also installed ispi performance for metrics and please clarify does NNMi also collects ping response time.

0 Likes
1 Solution

Accepted Solutions
Highlighted
Trusted Contributor.
Trusted Contributor.

Re: Monitor non snmp nodes using ICMP

Jump to solution

Hello,

hope you are doing well. 

to answer your question, for this kind of device that the only way to monitor is the ping the incident you should receive in NNM is NodeDown. 

if you have enable the Performance for metrics you can't see for this kind of nodes the reachability or availability as the device must be SNMP enable to show those reports.

 

Gwendolyne Maroto Artavia
Customer Support Engineer

If you find that this or any other post resolves your issue, please be sure to mark it as an accepted solution.
If you are satisfied with anyone’s response please remember to give them a KUDOS by clicking on the STAR at the bottom left of the post and show your appreciation. “

View solution in original post

1 Reply
Highlighted
Trusted Contributor.
Trusted Contributor.

Re: Monitor non snmp nodes using ICMP

Jump to solution

Hello,

hope you are doing well. 

to answer your question, for this kind of device that the only way to monitor is the ping the incident you should receive in NNM is NodeDown. 

if you have enable the Performance for metrics you can't see for this kind of nodes the reachability or availability as the device must be SNMP enable to show those reports.

 

Gwendolyne Maroto Artavia
Customer Support Engineer

If you find that this or any other post resolves your issue, please be sure to mark it as an accepted solution.
If you are satisfied with anyone’s response please remember to give them a KUDOS by clicking on the STAR at the bottom left of the post and show your appreciation. “

View solution in original post

The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.