Highlighted
Absent Member.
Absent Member.
484 views

NNM Command to retrieve total current trap count

I am aware of using the All Incidents or SNMP Trap view in the NNM console to get the total trap count, is there a command in NNM I can run to get the current total trap count from the command line?

0 Likes
1 Reply
Highlighted
Super Contributor.
Super Contributor.

Re: NNM Command to retrieve total current trap count

Hello,

You can try this one

# nnmhealth.ovpl -print verbose -filter EventsHealthAgent|grep "Snmp Traps"

    best regards

         Erno

HPE SW Support
If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.
0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.